Zoapi Hub > Technical > Firewall and Port guidelines for IT Administrators

Firewall and Port guidelines for IT Administrators

Created On
byzoapi

Applies to: Zoapi Hub v10.5600 and above Last Updated: 18-May-2019

Zoapi HUB is a plug and play device for your meeting rooms. Setting up Zoapi is very simple. All it requires is a display, power source and a network source preferably with internet. But sometimes it might be little tricky to set up a new device on heavily guarded corporate networks with firewalls and network rules. In this article we explain all the network requirements from Zoapi.

Zoapi Hub guidelines

  • If your network uses proxies, refer to the proxy details document available under the knowledgebase
  • Hub requires access to the internet, for the following sites:
  • Hub will route traffic from Wi-Fi access point through it. The traffic routing is from Wi-Fi access point to Ethernet/Wi-Fi link
    • To filter internet access rights, filter outgoing routes from the Zoapi Hub device
    • You can also set the WAN settings of Wi-Fi access point to disabled to block complete internet access over Wi-Fi access point
  • Network isolation
    • The Wi-Fi link and the Ethernet link are isolated: However client Devices will continue to be able to screen share from both networks. You can also connect another isolated Ethernet network using USB to Ethernet converter.
  • Ports: Zoapi Hub requires following ports to be open in the network for its communication between Zoapi Hub and internet and between Zoapi Hub and client device.
    • 2203
    • 56789
    • 56987
    • 9050
    • 9051
    • 53 (dns)

End-User guidelines

  • End users connect to the internet, to the following sites:
    • zoapi.com (http & https)
    • gstatic.com (https)
    • End user clients will also require port 53 (dns) to lookup share.zoapi.com
  • End user client only makes outgoing connections. No special firewall filtering is required
  • End user client runs in user mode, does not require admin rights on windows
  • End user client on Mac might request admin permissions for installation
  • Client device will connect to Zoapi Hub on following ports.
    • 2203
    • 56789
    • 56987
    • 9050
    • 9051

Please reach out to support@zoapi.com if you have any queries.